Products    /    Lab Equipments   /    SILAR Coating System
SILAR Coating System


Model: HO-TH-03

Holmarc’s SILAR Coating System has been designed to automate the entire process to avoid operator fatigue and errors associated with it. In manual SILAR process, the operator has to perform hundreds of repetitive dipping into the solution and water. It is very difficult to control dip duration and number of dips in a manual process which can last hours.

In this system, thin film is deposited on glass substrate following a chemical technique called Successive Ion Layer Adsorption and Reaction (SILAR). The process involves multiple dipping of the substrate in a given solution and deionized water, temperature of both can vary from case to case.

In the automated unit, the operator need just to clamp the subtract into the holder and program the controller with required dip cycles and duration.


    Actuator :     Stepper motor
    Drive mechanism :     Lead screw
    Dip duration :     0 - 99 seconds / minutes / hours
    Number of dips :     1 - 999
    Operating temperature :     Ambient to 80°C
    Power input :     230V, 50 Hz
    PC connectivity :     Serial port (RS 232)
    Stroke length :     75 mm
    No. of position for beakers :     6
    No. of samples could be loaded :     5
    No. of programs :     5
    Weight (appx.) :     44 Kg
This device can be customized as per requirement. Holmarc has developed models where a controlled heater is used for keeping each beaker at specified temperature independently.

Home | Products | Supports | Company | Contact Us

|

©2020 Holmarc Opto-Mechatronics (P) Ltd. All rights reserved.

Follow us